Contact Us

Changsha Hone Arts Co.,Ltd
TEL: +86-731-84886102

WhatApp:13975166561
E-mail: marketing5@hnarts.com
Address :RM 8033 FL 8 Tower B Wan Fu Hui Mansion 9 Shuang Yong RD PC 410003 Changsha China

Use of glue gun
2020-06-30 18:39
Use of glue gun
 
1. Before plugging the hot melt glue gun into the power supply, please check whether the power cord is intact and whether the supports are all equipped;Has used the glue gun whether has the reverse glue and so on phenomenon.
2. Please preheat the glue gun for 3-5 minutes before use, and stand on the table when not in use.
3. Please keep the surface of the hot melt strip clean to prevent impurities from blocking the nozzle.
4. If the glue gun cannot be made during use, please check whether the glue gun is hot;
 

 
If the glue gun cannot get hot normally, the reasons may be as follows:
1. The power supply of the glue gun is not plugged in;
2. The glue gun was burnt out due to short circuit.
 
When the glue gun is normally hot, the reasons may be as follows:
3, the nozzle due to impurities blocking out of the rubber mouth, should be professional treatment;
4, the glue gun pour glue to thicken the strip, at this point just gently rotate the strip around and carefully pull out a small part, strip off the strip thickening part, then continue to use.
5. Avoid using a sol gun in a humid environment. Humidity will affect the insulation performance and may lead to electric shock.
6, the nozzle and melt glue are very high temperature (about 200 degrees), except for the handle, do not contact other parts.

7, do not pull out of the rubber strip from the inlet, hot melt glue will cause serious burns or damage to melt glue gun.
8. Do not disassemble and install the electric parts, or it will cause failure.
9. Keep out of reach of children and keep out of reach of children.
10, in addition to melt glue, can not be used for any other purposes.
11. If the rubber strip in the glue gun backflows, please stop using it immediately, and use it only after the professionals clean the hot melt glue.
12. If the glue gun is heated continuously for more than 15 minutes, please cut off the power supply.